We have two new feature holds called dizygotic.. One of them is an sloper and other is a very positive jug. Each hold weigth around 15 lbs. But I dont know if the system fixation could be only one bolt and three or four pre drill screws... Like Element Climbing I dont like put an sliding bolt in special in this couple shapes.
Any feedback is welcome.
Wow, that is a big ol hold, congrats
I'd run a bolt and then screw holes
Not to sound whiny, but as a new shaper, what do you guys think of the holds i posted above...
I think that they look pinchy, I love the look of the left hand side holds what size are they as there's no reference. I'm also loving the look of the top right hand hold because it looks like a good pinch or a fun edge/crimp if it's vertical
Similar to the Moon Rocks from Sequence Climbing (I think they've gone under). It's hard to tell, I'd like to see a side profile if possible.
I dont have one for reference, but the biggest is about 6-8 inches long
Cool design... nice set.
Looks like some small radii on those edges. Might end up feeling sharp in hard finished form.
I always try to make things more comfy and friendly. When I'm done with a set.. I'll usually go back one more time and make the radii bigger.
Thanks for the feedback! This is a rough draft, as I'll do the final copy from density foam for black swan(shameless plug), and I plan on giving them a bit bigger radius. Thanks!
@Anonrights: Not sure if these are your shapes or not, but I've felt up some of black swan's newer holds and many of them have some very sharp edges, particularly on thumb catches. I'd say that's just something to look out for when running your final drafts.
You must log in to post.