Just came across this website while looking into hold making:
They've got a good bit of info on the basic processes in the "How To" section. Can those of you whom are well versed in hold-making give some comments on this companies information (is it right, wrong, ok, etc.)? How about the prices for the materials? High, low, average?
Thanks.
Prices are close for the resin but the material is crap and will most likely break under an impact gun. The silicone is a rip off. I dont get the thing with the bolt stuck in the mold seems like a waste of time.
Yes, you can make something to pull on with this kit - but the holds will never be commercially viable. It would also be difficult to scale up the production of holds with the approach this site recommends. This kit will work for fine for home use and a creative outlet. Look elsewhere if you plan to go 'big'.
Don't forget to wear the right safety gear. Many of these materials are carcinogenic.
You must log in to post.